The chamfer tool is designed to be used with an electric drill and is fitted with a 1/4″ quick-chuck shaft, maximum recommended speed is 400rpm. The tool is fitted with three super-hard High Speed Steel blades that make light work of repairing damaged bolts and damaged threads. The blades cut quickly and cleanly and are effective on stainless steel, hardened steel, mild steel, copper, brass, wood, fibreglass, and even hard plastic. Bolts, studs and threaded rod, size range from 3mm right up to 19mm. Hammer-damage or squashed and flattened threads will stop the retaining nut or wheel nut screwing back on; a couple of zaps from the deburr/chamfer tool solves the problem instantly.
- Effective on stainless steel, hardened steel, mild steel, copper, brass, wood, fibreglass, hard plastic.
- Size range 3 – 19mm; max speed 0 – 400rpm.
- HSS blade 1/4″ shank. Chamfer angle: 50 degrees (approx).
- For repairing damaged bolts
The Laser Tools range specialises in the automotive sector and our products are available through automotive wholesale outlets, motor factors, independent retailers, hardware stores and van sales.
We offer a full range of traditional high quality hand tools but we are also well known for our ever increasing range of special tools designed to make easy work of difficult and awkward jobs. These tools are the result of feedback from the sharp end of the automotive industry - the actual technicians working on today's motor cars. When a problem is identified on specific vehicles our engineers devise a solution that is both cost effective as well as making the job easier for the technician - usually meaning that the work can be carried out on the vehicle in situ - rather than removing sub-assemblies and then removing and replacing the faulty component on the workshop bench.
Only logged in customers who have purchased this product may leave a review.